RF4 RF-HD11A IC Prying Blade Set 4in1 with Handle

Professional IC Prying Blade Set for PCB Glue Removal

The RF4 RF-HD11A gives you a professional IC prying blade set for the glue-heavy side of board repair. You get four blades and one handle that holds blades up to 6mm wide. When you start IC change karna on a dead phone mainboard, cured adhesive blocks the chip edges and slows every step. This set clears that glue and pries the chip free with one compact tool. RF4Tools Pakistan stocks it for benches that need clean, controlled removal without a bulky kit.

Handle and Blade Design

The handle grips blades up to 6mm wide, so you choose the edge that fits the job. You fit a flat blade for glue sheets along the board edge and a narrower blade for tight chip corners. Straight and curved standard blades both fit, which keeps your blade choice open when the included four wear down. You hold one handle for every task, so your hand stays on a familiar grip while you change edges. That consistency matters when you work under a microscope and every millimetre counts.

Where It Fits in Your Repair Workflow

Board-level repair follows a steady order, and this set covers the middle of it. You test with a multimeter, find the faulty IC, and heat the board on your hot air station. The RF-HD11A then clears glue around the chip and lifts the IC once the solder softens. After that you clean the pads with your soldering station, then reball or fit the new chip. Technicians use this order on charging issue boards, hardware fault boards, and phones that stay dead after flash. The PCB glue removal blade step decides whether the chip lifts clean or tears a pad, so the right blade saves the whole board.

Handling Tips for Cleaner Results

Clamp the board in a PCB holder before you cut or pry. Apply even heat first so the adhesive softens and the solder loosens. Slide the blade under the glue edge in short passes, and never force a chip that resists. Lift the corner gently, check under the microscope, and then continue. Slow, steady pressure protects the pads and neighbouring components. Swap to a thinner blade when you work close to small parts, and keep every blade clean so glue residue does not drag across the board.

Why Technicians Buy This Set

Repair shops across Pakistan run high volumes of board jobs, and a single worn blade slows the whole day. This set keeps four blades and a flexible handle in one place, so you replace the blade and keep the handle. You spend less on tooling and waste less time hunting for the right edge. The RF-HD11A also suits technicians who step up from basic opening tools to proper board-level work, because it sits well beside RF4 scraper tools and your reballing kits. Whether you run a one-man bench or a busy service center, this set earns its place in the daily tool tray.