RF4 PO18 Professional Heat Insulation Working Mat

Professional Heat Insulation Mat Built for Compact Bench Work

The RF4 PO18 is a professional heat insulation mat that gives your repair bench a clean, safe working surface in a 26 × 18 cm footprint. It uses antistatic silicone, so your soldering iron, hot air gun and tweezers work on a surface that tolerates bench heat and stays put. If you handle motherboards all day, a dedicated mat protects your table from scorch marks. It also keeps small parts where you place them.

Compact Footprint for Microscope and Hot Air Work

At 26 × 18 cm, the PO18 slides under a stereo microscope or beside a hot air station without taking over your bench. You keep the board, flux, solder wire and tweezers inside one tight zone. Shops with shared tables gain the most. You lift the mat, wipe it and clear the space when the job ends.

Larger RF4 silicone mats suit technicians who spread several phones across the bench. For one board at a time, this size keeps your reach short and your hand movement steady. Your eyes stay on the microscope instead of hunting for tools.

Antistatic Silicone Surface for Soldering and Rework

The PO18 uses antistatic, heat-resistant silicone. The surface handles contact from soldering and rework tools, so a stray touch from your iron tip no longer burns your table. The anti-slip finish grips the board while you remove an IC or clean pads under magnification. A board that slides mid-job ruins a clean pad.

Silicone resists corrosion and washes clean with water and mild soap. Flux residue and solder splashes wipe off after a long shift. Keep the hot air nozzle moving. Never hold it on one spot of the mat, because every silicone surface has a heat limit.

Pair the mat with your soldering station, hot air station and PCB holder. Keep a multimeter beside it for continuity checks before you power the board.

Repair Jobs You Run on the PO18

Most hardware fault jobs start on a mat like this. IC change karna, charging port and charging IC work, jumper lagana on broken tracks, small BGA reballing, display connector repair and board cleaning all need a safe, clean surface. On a dead phone job, you open the board and probe it with your multimeter. Then you rework the faulty section right on the mat.

Phones with a boot loop issue or hang on logo after a hardware fault follow the same path. The board comes out, sits on the PO18 and goes under the microscope. Stock reballing kits, stencils and flux next to the mat and you run the whole job from one spot.

The PO18 also works as a small parts tray surface. Screws, shields and flex cables stay on the silicone instead of rolling off your bench. Technicians who document each step of a repair keep their workspace cleaner and avoid lost parts.

For a full bench, start with a mat, then add a hot air station, a soldering station, a microscope and a reballing kit. The PO18 is an affordable first step.