RF4 RF-H7 2-in-1 Hot Air Gun & Soldering Station

Professional 2 in 1 Rework Station for Mobile Board Repair

A professional 2 in 1 rework station earns its bench space when it handles hot air and iron work without a second power point. The RF4 RF-H7 does exactly that. It pairs a 600W hot air gun with a 50W 936 series soldering iron and gives you one digital display for both. You lift a BGA chip, clean the pad, and tack a jumper wire in one sitting. For Pakistani repair shops that fight dead phone and charging issue jobs all day, that flow saves minutes on every board.

Where the RF-H7 Sits in Board-Level Repair

Board-level repair follows a fixed order: you diagnose with a multimeter, find the faulty part, remove it, clean the pads, fit the new part, and test. The RF-H7 covers the middle of that chain. The hot air gun softens solder under BGA and SMD chips so you lift them off the motherboard. The iron then clears leftover solder from the pads and places jumper wires on damaged tracks. Technicians who do IC change karna on a hardware fault board need both steps within arm’s reach, and this station puts them there. Pair it with a microscope for pad inspection and a PCB holder to keep the board steady while the gun works.

Hot Air Gun and Iron on One Station

The air gun and the iron run as separate tools with independent switches. You switch on only the gun for a chip lift, only the iron for a quick joint, or both at once when a job needs it. That matters on crowded mobile boards. You can preheat the area with hot air while you reposition a jumper with the iron. The 600W hot air gun suits BGA and SMD rework on phone motherboards. Your hot air station stays free of cable clutter because the iron plugs into the same unit instead of sitting on a second power supply.

Digital Touch Display and Control

The RF-H7 uses a large digital display with touch control, and it shows the hot air gun and soldering iron readings in real time. You read both temperatures at a glance instead of guessing from knob positions. That helps when you repeat the same job fifty times a week, such as a charging IC swap on a boot loop board. Set the temperature, watch it settle, and start the rework with confidence. The soldering iron covers a 150°C to 500°C range, so you can match the setting to the part and the solder you use.

Ceramic Heating Core and 936 Series Tip

The iron uses a plug-in ceramic heating core, which keeps replacement quick and keeps your bench running when a core wears out. The station ships with a 936 series soldering iron tip, and the 936 series is a common format in repair workshops. You swap the core, not the whole handle, so a worn element never stops a repair day. Clean the tip often, tin it before you shut down, and it stays ready for fine pad work like lifting a bridge on a charging port or re-tinning a damaged pad.

What You Get and How Shops Use It

The package includes the hot air gun handle, the soldering iron handle, and one 936 series soldering iron tip. Workshops in Pakistan use this setup for frequent jobs: hang on logo boards that need an eMMC or CPU touch-up, display problem boards with damaged connectors, network issue boards with a lifted filter, and dead after flash boards that need a hardware check. If you build a full bench, add reballing kits for chip work, a test box for fault tracing, and ISP pinout tools for dead phone data jobs. The RF-H7 sits at the heart of that bench as the heat source for everything you lift and fit.