RF4 RF-FT06 Mini Glass PCB Fixture

RF4 RF-FT06 Mini Glass PCB Fixture for Chip-Level Repair

The RF4 RF-FT06 mini glass PCB fixture gives you a stable, heat-resistant platform for chip-level work on phone motherboards. A board that shifts under the hot air nozzle ruins a reflow, lifts pads, and burns your time. The RF-FT06 removes that problem. You slide the board into the universal chip slot, turn the knob, and the clamp holds the PCB firm while you work. RF4 built it as the compact option in its fixture range, so it fits a crowded repair bench in a Pakistani workshop. Pair it with your hot air station and microscope, and you get a repeatable setup for IC change karna and CPU reflow.

Knob Clamping and Glass Platform of the RF-FT06 Motherboard Holder

The RF-FT06 uses knob clamping with a slider that moves smoothly and does not stick. You tighten by hand, so you feel the grip before you apply heat. Two-way movement lets you shift the board along both directions, which helps with irregular Android boards that never sit square in a basic holder. The universal chip slot structure positions the board quickly and holds it without wobble.

The platform surface is heat-insulating glass that resists 500°C+ and keeps its shape after long use. Flux and residue wipe off the glass between jobs, so your next board starts on a clean surface. The glass also limits how much heat travels through the platform.

Loading a board takes three moves. Open the slider, seat the PCB against the chip slot, and turn the knob until the board stops moving. Tap it lightly to check the grip before you bring in the hot air gun.

Repair Workflow Fit

Use the fixture at the hot air stage of any hardware fault job. Typical work includes removing and replacing ICs, degumming chips, reflowing CPUs, and reballing after a failed chip. A dead phone with a suspected hardware fault needs the board held still while you heat, inspect, and probe test points with your multimeter. Whether you plan jumper lagana or a full IC change karna, the board has to stay put.

Charging issue, display problem, and network issue repairs follow the same pattern. You lift the suspect IC, clean the pads under the microscope, and reball or replace the chip. Dead after flash cases that trace back to a bad chip joint also end up on the fixture once you decide to reflow or replace. After the chip work, verify the repair with your test box, ISP pinout tool, eMMC programmer, or UFS adapter, depending on the storage type.

Chip degumming deserves its own mention. Glue and underfill slow every CPU and IC job, and a loose board makes the cleanup worse. A fixed board lets you heat, scrape, and clean with steady pressure, which protects pads and neighbouring components. When your jobs outgrow the mini format, step up to a larger holder from the PCB Holders category, and keep reballing kits and a soldering station within reach.

Why the Mini Glass PCB Fixture Suits Daily Rework

A mini format makes sense for shops that handle phone boards all day. The RF-FT06 sets up fast, sits in a drawer between jobs, and moves from your hot air station to your soldering station without taking over the bench. In a busy Pakistani repair market, a fixture that holds the board in seconds saves minutes on every ticket.

The clamp also holds CPUs, hard disk chips, and other ICs, so one fixture covers odd jobs beyond phone boards. Compatibility with most common Android motherboard shapes means you rarely hunt for a second holder mid-repair. The package contains one fixture. Check your board against the slot before ordering if you mostly work on large boards, and move to a larger RF4 holder for those jobs. RF4 Tools Pakistan offers the RF-FT06 for technicians, repair shop owners, and service centers who want a clean, predictable clamp at the rework stage.