RF4 RF-PO15 Silicone Repair Pad With Storage Bracket

Silicone Repair Pad for a Cleaner Rework Bench

The RF4 RF-PO15 silicone repair pad gives you a 450 x 280 mm heat-resistant surface for motherboard work. You place the board, the ICs, and the screws on one mat instead of the bare bench. Hot air rework, BGA soldering, and IC change karna all happen on this surface, so the base under your work matters. This model comes with a storage bracket, so small parts stay close while your hands stay on the board.

Insulating Base for Hot Air and BGA Work

RF4 lists the RF-PO series as heat-resistant insulation silicone pads for mobile phone, tablet, and computer motherboard IC chip BGA soldering repair. Silicone gives you a non-metal base under the board, and it protects the table from stray heat during rework. You set the board down, run your hot air gun, and lift the chip without worrying about the surface below.

Keep your usual hot air settings. The pad does not replace a PCB holder, but it gives the holder, the board, and your tweezers a stable working area. Technicians who handle many boards per day notice the difference when the bench stays tidy and free of scorch marks.

Storage Bracket and Mat Size

The 450 x 280 mm surface gives you room for a full phone board plus the parts you remove from it. Lay out screws in the order you take them out. Park the shield cover, the flex connectors, and the loose ICs in one corner. Small parts stop rolling off the table, and you stop hunting for a screw when the phone is half-assembled.

The storage bracket adds a place for tools and small items you reach for repeatedly. Tweezers, a spudger, and a few spare parts sit where you can see them. Your workflow gets shorter because every item has a spot, and that matters when you repair ten boards before lunch.

Where the Pad Fits in Your Repair Workflow

Every board that comes in with a dead phone, a charging issue, a display problem, or a hang on logo fault goes through the same steps: open, inspect, test, rework, and verify. The RF-PO15 supports each step as a stable surface. During diagnostics, rest the board on the mat while you check readings with your multimeter. During rework, keep the board on the pad beside your hot air station or soldering station. During reballing, hold the chip and the stencil on the same clean surface.

You can run it next to your existing setup. A pad this size sits easily beside a PCB holder, a microscope, and a reballing kit. Technicians who solder at the same spot every day often add a second mat for the test side of the bench, so rework debris stays away from the boards waiting for power-on checks.

Choose this pad when you want a dedicated, organised surface for jumper lagana, IC replacement, and general motherboard repair without spending on a full workstation. It suits repair shop owners who want consistent benches for every technician, and service centers that train new staff on tidy board handling. The silicone surface and the storage bracket make it a practical upgrade from a bare table or a loose foam sheet. For Pakistani workshops that run long days, a clean mat saves time on every single board.